$275.00
A seller in Wisconsin has put together a package of milk pump parts. See the details listed below. This package is labelled Reference# DTCA-0168. Contact Dairy Train by phone or email about purchasing this pump package!
- Two (2) used milk pump heads that are both measured 6 inches from top to bottom with 3/8 inch inlet and 1 1/2 inches plastic “spy” tube. The base is 4 1/2 inches outside diameter and the output pipe is 1 3/8 inches outside diameter. ONE has a Surge ferrule and the other ONE has a glass ferrule, and that one includes an old gasket and rubber stopper.
- Two (2) stainless steel impellers that measure 3/4 inch inside diameter of the mounting center hole.
- Two (2) shafts that both measure 3 1/2 inches long and 3/4 inch outside diameter on the small end and 1 1/4 inches diameter on the larger end.
- One (1) spring that fits the shaft. The stainless steel spring is 1 1/4 inches long.
- Two (2) mounting J-shaped brackets. They are 1/4 inch thick. The upper part of the J is 1 3/4 inches long and the squared off bottom is 3/4 inch wide. The holes measure 3/8 inch outside diameter.
- Two (2) bolts and wing nuts. The bolts are marked “THE S30400” and measure 3/4 inch long, and fit 3/8-24 on our thread-sizer.
- Two (2) shank headless bolts that are 3/8 inch outside diameter and 2 3/4 inches long. Note the threads: the 1/2 inch long thread fits 16-24 on our thread-sizer and the 1 1/4 inches long thread fits 3/8-24The on our thread-sizer.
- One (1) trap with rubber ball
- One (1) stainless steel ring that has an adjustable outside diameter that now measures 1 1/2 inches. The metal is rounded 1/8 inch diameter.
- One (1) funnel or nipple with a Surge ferrule and no gasket. The ferrule end is 2 inches diameter. The nipple end is 5/8 inch diameter. The whole thing measures 2 inches long.
See our FAQ section for our Refund, Warranty, and Right of Return policies.